Total stroke piston reciprocating plunger L Texas constant radial piston pump, the decision by the cam lift. Plunger fuel supply amount per cycle depends on the size of the oil hydraulic radial piston stroke, stroke oil from the camshaft control is variable. Oil supply start time does not change with the stroke change. Rotation of the plunger end time can change the oil, thereby changing the amount of oil. When the piston pump work, under the action of the cam on the camshaft and injection pump radial piston pump plunger spring, forcing the plunger for the upper and lower electric radial piston reciprocating motion, thus completing the task of pumping, the pump Oil can be divided into three stages. Note 1, the pump installation dimensions shown in Figure, the upper flange and φ63f8 and 4-M8.2, this pump working medium YB-N32 hydraulic oil can not easily replace other grades of oil, and to ask 120 mesh strainer filtered. 3, pump normal operating temperature of 20-60 ℃, high oil temperature cooling measures shall be adopted, oil temperature is too low may not directly work shall be warmed before work. 4, pump installation, pay attention to the center line of the inlet must not exceed 500mm. 5, before the inlet portion is not filled with fluid, the pressure should not be allowed to start. 6, the pump pressure shall not exceed the rated pressure of the pump, so as not to affect the normal use. Yan'an radial piston pump, Shandong Hydraulic, double radial piston pump is provided by the Texas Lu of the hydraulic machinery plant. Yan'an radial piston pumps, hydraulic power Lu, Lu Texas double radial piston hydraulic equipment plant (www.luliyeya.com) this year introduced a new upgrade, the above picture is for reference only, please call this page or Tel picture on to obtain the latest information, contact: Lu Jingli.